Running SWAT+

You can run the model in the 'Run Model' section or in the 'Calibration' section under the 'Manual Calibration' sub-section.

Run Page

Go to the 'Run Model' section and make sure you have selected the desired model revision/version in the right corner. To run the model, click on the big 'Play' button. You will see progress on the local progress bar in the 'Run Model' Page and on the global progress bar at the bottom. While the model is running, settings are disabled and are automatically re-enabled as soon as the model finishes running.

You can also stop the model run using the big 'Stop' Button which the 'Play' button becomes when the model is running.

In Mannual Calibration Section

You can also run the model in the 'Calibration' section under 'Manual Calibration'. It is, however, important to know that the run under 'Manual Calibration' first applies parameters as displayed on the 'Manual Calibration' page and then runs the model where as the run in the 'Run Model' section will run the model after applying run settings (such as Routing, PET and print settings, but no parameter modification).